Tensile Comp CNC 7075 Trials Cranks
Tensile Comp CNC 7075 Trials Cranks
- Model:Trial Crank Set
- A top of the range original Trial crank set made from 7075 T6 Heat treated Alloy.
- 170 or 175 mm elegant CNC machined ultra stiff but super light cranks.
- Threaded top spigot on R/H crank for fitting freeweel or screw-on bash.
- Isis drive cranks for super secure driving.
- Steel 9/16” threaded pedal inserts for ultra secure pedal fitting.
- Incredibly light but stiff Trials cranks for 20"/24"/26" cycle.
- Weight: Cranks alone - 477 grams
Super light but ultra strong and stiff crankset from Tensile, designed specifically for bicycle Trials. Fine CNC machining with ISIS drive and Cromoly pedal inserts. Fits most types of Freewheel.
Ensure that your pedals are tightened to at least 310 in-lbs (35 Nm) every 5 minutes for the first few rides. Before fitting, it's also a good idea to make sure your pedal axles are clean (a wire brush works well) then greased before installation.
Similarly, always check crank bolt torque is at least 310 in-lbs (35 Nm) every 5 minutes for the first few rides, then each and every ride after that.
Failure to keep your pedals or crank bolts tight as described above is likely to damage your cranks and this will not be covered under warranty.
Please note that the minimum required thread contact between crank arm and sprocket/freewheel is 7mm, and a 1.37" sprocket/freewheel with maximum internal thread diameter 33.80mm (NOT 1.375") must be used. Failure to adhere to this instruction will damage the cranks threads and this is not covered under warranty.
Ensure that your pedals are tightened to at least 310 in-lbs (35 Nm) every 5 minutes for the first few rides. Before fitting, it's also a good idea to make sure your pedal axles are clean (a wire brush works well) then greased before installation.
Similarly, always check crank bolt torque is at least 310 in-lbs (35 Nm) every 5 minutes for the first few rides, then each and every ride after that.
Failure to keep your pedals or crank bolts tight as described above is likely to damage your cranks and this will not be covered under warranty.
Please note that the minimum required thread contact between crank arm and sprocket/freewheel is 7mm, and a 1.37" sprocket/freewheel with maximum internal thread diameter 33.80mm (NOT 1.375") must be used. Failure to adhere to this instruction will damage the cranks threads and this is not covered under warranty.
